Loss on drying 731
Dry about 100 mg, accurately weighed, in vacuum at a pressure not exceeding 5 mm of mercury at 60
for 3 hours: it loses not more than 1.5% of its weight.
Assay
pH 6.8 buffer, Mobile phase, Internal standard solution, Standard preparation, and Chromatographic system
Prepare as directed in the
Assay under
Cefmenoxime Hydrochloride.
Assay preparation 1
(where it is represented as being in a single-dose container)Constitute a container of Cefmenoxime for Injection in a volume of water, accurately measured, corresponding to the volume of diluent specified in the labeling. Withdraw all of the withdrawable contents, using a suitable hypodermic needle and syringe, and quantitatively dilute with water to obtain a solution containing the equivalent of about 1 mg of cefmenoxime (C16H17N9O5S3) per mL. Transfer 4.0 mL of this solution to a 50-mL volumetric flask, add 20.0 mL of Internal standard solution, dilute with Mobile phase to volume, and mix. This solution contains the equivalent of about 80 µg of cefmenoxime per mL.
Assay preparation 2
(where the label states the quantity of cefmenoxime in a given volume of constituted solution)Constitute a container of Cefmenoxime for Injection in a volume of water, accurately measured, equivalent to the volume of diluent specified in the labeling. Quantitatively dilute an accurately measured volume of the constituted solution with water to obtain a solution containing about 1 mg of cefmenoxime (C16H17N9O5S3) per mL. Transfer 4.0 mL of this solution to a 50-mL volumetric flask, add 20.0 mL of Internal standard solution, dilute with Mobile phase to volume, and mix. This solution contains the equivalent of about 80 µg of cefmenoxime per mL.
Procedure
Proceed as directed for
Procedure in the
Assay under
Cefmenoxime Hydrochloride. Calculate the quantity, in mg, of cefmenoxime (C
16H
17N
9O
5S
3) withdrawn from the container or in the portion of constituted solution taken by the formula:
1.6(L / D)(WS PS / 1000)(RU / RS),
in which
L is the labeled quantity, in mg, of cefmenoxime (C
16H
17N
9O
5S
3) in the container or in the volume of constituted solution taken;
D is the concentration, in µg of cefmenoxime per mL, of
Assay preparation 1 or
Assay preparation 2, based on the labeled quantity in the container or in the volume of constituted solution taken, respectively, and the extent of dilution;
WS is the weight, in mg, of
USP Cefmenoxime Hydrochloride RS taken to prepare the
Standard preparation;
PS is the designated cefmenoxime (C
16H
17N
9O
5S
3) content, in µg per mg, of
USP Cefmenoxime Hydrochloride RS; and
RU and
RS are the response ratios of the cefmenoxime peak to the internal standard peak obtained from the
Assay preparation and the
Standard preparation, respectively.