Packaging and storage—
Preserve in well-closed, light-resistant containers. Store at 25
, excursions permitted between 15
and 30
.
Identification—
Triturate a quantity of finely powdered Tablets, equivalent to about 5 mg of ergotamine tartrate, with 10 mL of solvent hexane for a few minutes, allow to settle, and discard the solvent hexane extract. Add to the residue 10 mL of chloroform saturated with ammonia (prepared by shaking chloroform with ammonium hydroxide, then drawing off the chloroform layer), triturate for a few minutes, filter, and evaporate the filtrate on a steam bath to dryness. Dissolve the residue in a mixture of 4 mL of glacial acetic acid and 4 mL of ethyl acetate. To 1 mL of this solution add slowly, with continuous agitation and cooling, 1 mL of sulfuric acid: a blue color with a red tinge develops. Add 0.1 mL of
ferric chloride TS, previously diluted with an equal volume of water: the red tinge becomes less apparent and the blue color more pronounced.
Dissolution 
711
(for Tablets intended to be swallowed)—
Medium:
tartaric acid solution (1 in 100); 1000 mL.
Apparatus 2:
75 rpm.
Time:
30 minutes.
Procedure—
Determine the amount of (C
33H
35N
2O
5)
2·C
4H
6O
6 dissolved from fluorescence intensities, using the maximum excitation wavelength at about 327 nm and the maximum emission wavelength at about 427 nm, of filtered portions of the solution under test, suitably diluted with
Medium, if necessary, in comparison with a Standard solution having a known concentration of
USP Ergotamine Tartrate RS in the same
Medium.
Tolerances—
Not less than 75% (Q) of the labeled amount of (C33H35N2O5)2·C4H6O6 is dissolved in 30 minutes.
Assay—
Mobile phase—
Prepare a filtered and degassed mixture of acetonitrile and 0.01
M monobasic potassium phosphate (55:45). Make adjustments if necessary (see
System Suitability under
Chromatography 621.
Internal standard solution—
Transfer about 40 mg of ergonovine maleate to a 250-mL volumetric flask, add a mixture of acetonitrile and water (55:45) to volume, and mix.
Standard preparation—
Transfer about 10 mg of
USP Ergotamine Tartrate RS, accurately weighed, to a 50-mL volumetric flask, add a mixture of acetonitrile and water (55:45) to volume, and mix. Transfer 5.0 mL of this solution to a 50-mL volumetric flask, add 5.0 mL of
Internal standard solution, dilute with the mixture of acetonitrile and water (55:45) to volume, and mix to obtain a solution having a known concentration of about 0.02 mg of
USP Ergotamine Tartrate RS per mL.
Assay preparation—
Transfer a number of whole Tablets, equivalent to about 10 mg of ergotamine tartrate, to a 500-mL volumetric flask. Add 50.0 mL of Internal standard solution, 300 mL of a mixture of acetonitrile and water (55:45), and sonicate for about 10 minutes. Dilute with the mixture of acetonitrile and water (55:45) to volume, and mix. Filter through a 0.45-µm membrane disk, discarding the first 25 mL of the filtrate.
Chromatographic system
(see
Chromatography 621)—The liquid chromatograph is equipped with a 254-nm detector and a 3.9-mm × 30-cm column that contains packing L1. The flow rate is about 1 mL per minute. Chromatograph the
Standard preparation, and record the peak responses as directed for
Procedure: the resolution,
R, between the analyte and internal standard peaks is not less than 3.0; the column efficiency determined from the analyte peak is not less than 3000 theoretical plates; the tailing factor for the analyte peak is not more than 2.0; and the relative standard deviation for replicate injections is not more than 2.0%.
Procedure—
Separately inject equal volumes (about 20 µL) of the
Standard preparation and the
Assay preparation into the chromatograph, record the chromatograms, and measure the responses for the major peaks. The relative retention times are about 0.7 for ergonovine maleate and 1.0 for ergotamine tartrate. Calculate the quantity, in mg, of (C
33H
35N
5O
5)
2·C
4H
6O
6 in the portion of Ergotamine Tartrate Tablets taken by the formula:
500C(RU / RS),
in which
C is the concentration, in mg per mL, of
USP Ergotamine Tartrate RS in the
Standard preparation, and
RU and
RS are the peak response ratios obtained from the
Assay preparation and the
Standard preparation, respectively.
